Installation Guide

page 8
reverse
switch
11. Testing Your Fan.
light
pull chain
extension
fan
pull chain
extension
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with pull chain on switch housing.
Start at the OFF position (no blade movement).
First pull will set the fan to HI. Second pull will
set the fan to MEDIUM. Third pull will set the
fan to LOW. Fourth pull will again set the fan to
the OFF setting. Test lights with pull chain in the
middle. If fan and/or lights do (does) not
function, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season. A ceiling fan will
allow you to raise your thermostat setting in
summer and lower your thermostat setting in
winter without feeling a difference in your
comfort.
Attach pull chain extensions supplied or
custom pull chain extensions (sold separately)
to the ends of the pull chains.
motor
housing
switch
housing