Installation Guide

FINAL INSTALLATION

Partially insert three blade screws (AA), along with

three rubber blade washers (BB), to attach one

blade arm (F) to a blade (G). (Make sure to

attach blade (G) with ridged side facing up and

flat side facing the blade arm (F). Note label

indicating THIS SIDE UP.) Then, tighten each

blade screw (AA) starting with the one in the

middle. (Fig. 2) Repeat with remaining blades (G).

Blade Screw x15

Rubber Blade Washer x15

Hardware Used

Locate two canopy mounting screws (N) on

underside of mounting bracket (C) and remove

canopy mounting screw (N) closest to the open

end of the mounting bracket (C). Partially loosen

the other canopy mounting screw (N). Lift canopy

(B) to mounting bracket (C). Place rounded part of

slotted hole in canopy (B) over loosened canopy

mounting screw (N) in mounting bracket (C) and

push up. Twist canopy (B) to lock. Re-insert

canopy mounting screw (N) that was removed,

and then tighten both canopy mounting screws

(N). Slide canopy cover (I) up to canopy (B),

aligning rounded part of slotted holes in canopy

cover (I) with screwheads in bottom of canopy (B).

Turn canopy cover (I) to the right (clockwise) until

it stops. (Fig. 1)

Locate motor screws (J) and lock washers (K) that

were removed in Step 5 on page 7.

Insert two motor screws (J), along with lock washers

(K), through one blade arm (F) to attach blade arm

(F) to motor. Tighten motor screws (J) securely.

(Fig. 3) Repeat with remaining blade arms (F),

making sure to completely secure each blade arm

(F) before proceeding with the next.