Installation Guide

FINAL INSTALLATION
13
5.
Remove one fitter plate screw (T) from post on
underside of fitter plate (P) and loosen the other
two fitter plate screws (T). (Fig. 5)
4.
Remove one motor plate screw (U) from underside
of motor and loosen the other two motor plate
screws (U). Align slotted holes in middle of fitter
plate (P) with loosened screws in motor plate,
allowing male plug from motor housing (E) to come
through hole in middle of fitter plate (P). Twist fitter
plate (P) to lock. Re-insert motor plate screw (U)
that was just removed, and then tighten all three
motor plate screws (U) securely. (Fig. 4)
6.
Connect large female plug from light kit fitter (H) to
large male plug from motor housing (E), matching
up the colors on the male plug with the colors on
the female plug for correct fit. (Fig. 6) Make sure
plugs connect tightly.
Connect small female plug from light kit fitter (H) to
small male plug from fitter plate (P). (Fig. 6) Make
sure plugs connect tightly.
5
E
4
E
6
P
Male
Plug
E
Female
Plug
(small)
Female
Plug
(large)
Male
Plug
(large)
Male
Plug
(small)
P
H
U
Motor
Plate
P
T
U