Installation Guide

FINAL INSTALLATION

Align slotted holes in light kit fitter (H) with

loosened screws in fitter plate (P). Re-insert fitter

plate screw (T) that was previously removed.

Securely tighten all three fitter plate screws (T).

(Fig. 7)

Remove finial (S), finial plate (R) and threaded

washer (Q) from light kit fitter (H). (Fig. 8) Save

finial (S), finial plate (R) and threaded washer (Q)

for later use.

Install three candelabra-base 40-watt max. bulbs

(W) provided. (Fig. 8)

CAUTION: When replacing bulbs, please allow

bulbs and glass shade to cool down before

touching.

Raise glass shade (O) in order to guide pull chains

through corresponding holes at the bottom of the

glass shade (O). Align center hole in the glass

shade (O) with threaded rod on light kit fitter (H)

and push up gently on glass shade (O) until

threaded rod comes through hole. (Align fan pull

chain so that it does not rub against light bulbs

when fan is in operation.) Secure glass shade (O)

with threaded washer (Q) that was previously

removed. (Fig. 9)

Note: Do NOT overtighten threaded washer (Q) as

glass may crack or break.

Thread pull chains through appropriate holes in

finial plate (R) and push up on finial plate (R),

allowing threaded rod to come through hole in

middle of finial plate (R). Thread center pull chain

through hole in finial (S). Tighten finial (S) to

secure glass shade (O) to light kit fitter (H). (Fig. 9)

Note: Do NOT overtighten finial (S) as glass may

crack or break.

Threaded

Rod