Installation Guide

If you decided to cut back the lead wires in Step 4,

strip 1/2 in. of insulation from end of white wire.

Twist stripped ends of each strand of wire within

the insulation with pliers. (Fig. 5) Repeat Step 5 for

black, blue (if applicable) and green wires.

FAN MOUNTING

Install ball end of downrod (A) into mounting

bracket (C) opening. Align slot in ball with tab in

mounting bracket (C). (Fig. 6)

DANGER: Failure to align slot in ball with tab

may result in serious injury or death.

WARNING: To reduce the risk of fire, electrical

shock, or personal injury, wire connectors provided with

this fan are designed to accept only one 12-gauge

house wire and two lead wires from the fan. If your

house wire is larger than 12-gauge or there is more

than one house wire to connect to the two fan lead

wires, consult an electrician for the proper size wire

connectors to use.

CAUTION: Be sure outlet box is properly grounded

and that a ground (green or bare) wire is present.

WARNING: If house wires are different colors than

referred to in the following steps, stop immediately. A

professional electrician is recommended to determine

wiring.

WIRING

Hanging

Ball Slot

Tab