Use and Care Manual
Construction Manual
© 2007 Little Cottage Co.
Page 2
Gambrel Barn Units - 8x8 through 12x24
7
12
Install the remaining wall section(s) in a similar
manner.
8
Locate the end wall section (without doors) and slide
into place.
9
Note that the end wall section’s base 2X will rest on
the oor while the remaining 2X’s will abut with the
vertical 2X’s on the side wall sections.
10
From the outside, hold the end wall section rmly in
place.
From below, drive a 2½” screw through the overhang
and into the end wall’s 2X eave. Then, repeat steps
#11 and #12 on the opposite corner.
11
While holding the end wall in place, use an angle
square to ensure that the end wall and side wall
sections are ush. Then drive a 2½” screw through
the 2X eave and into the side wall.
Gambrel Barn Units- 8x8 through 16x24
®