Use and Care Manual

Tool Bungee Instructions
For extra tension
tie an overhand knot
1
3
1
2
3
2
Standard use
Little Giant Solutions
1198 N. Spring Creek Place
Springville, UT 84663
Toll Free: 800-453-1192
Phone: [phone]
Fax: [phone]
www. LittleGiantLadders.com
© 2008 Little Giant Solutions 52378.2.5
Project Tray
Operating the Project Tray
Use the project tray on your Little Giant Ladder in the
A-frame position. To attach the Project Tray to your
ladder, please follow these steps:
1. Place the Project Tray hooks on the rung below
your desired platform height and then place the lip of
the tray over the next rung up. (see Figure 1)
2. Ensure the Project Tray is secure before putting
tools on it. (see Figure 2)
3. When you are finished using the Project Tray,
simply fold it and store it inside ladder
(see Figure 3)
Warning: Do not sit or stand on the Project Tray
Figure 1 Figure 2 Figure 3
Warning: Do not exceed max weight of 25 lbs.
LITTLE GIANT PROJECT TRAY
WARRANTY
Little Giant Solutions, Inc. warrants each new Project Tray, to original
purchaser thereof, to be free from defects in workmanship and materials when
operated under normal conditions and maintained properly. This warranty
covers all parts of the Work Project Tray.
This warranty shall be in effect for a period of one year from date of purchase.
This shall be in lieu of any other warranty, expressed or implied, including, but
not limited to, any implied warranty of merchantability or fitness for a particular
purpose. Certain states do not allow limitations on how long an implied
warranty lasts. The above limitation may not apply.
Little Giant Solutions, will repair or replace, at its option and without cost to the
original purchaser, any Project Tray which has been found defective and is
within the period of warranty. All freight to and from factory is to be paid by the
customer. The factory address is: Little Giant Solutions, 1198 N. Spring Creek
Place, Springville, Utah 84663.
The liability of Little Giant Solutions, Inc. under this warranty shall be limited
solely to repair or replacement of the Project Tray within the warranty period.
Little Giant Solutions, shall not be liable, under any circumstances, for conse-
quential or incidental damages, including, but not limited to, personal injury or
labor costs. Some states do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitations or exclusion may not
apply to you. This warranty gives the original purchaser specific legal rights,
and you may have other rights which vary from state to state.
Under no circumstances will Little Giant Solutions, Inc., be responsible for any
expense in connection with any repairs made by anyone other than the factory
or authorized service station unless such repairs have been specifically autho-
rized in writing by Little Giant Solutions.
The Project Tray is a great addition to the Little Giant family. The Project Tray enables you to
do a wide variety of jobs with features for just about everything you need, including the
following:
• Oversized magnetic tray for screws, nuts, bolts, etc.
• Drill holder
• Fitted trays for all standard paint can sizes, including quart and gallon (round and square)
• Screwdriver holes
• Slot for putty knives and speed square
• Drink holder
• Slotted holes for wrenches, extension cords,
and Tool Bungees