Installation Sheet

ManualsBrandsLivex Lighting ManualsChandeliersLivex Lighting Carlisle 5 Light 22" Wide Drum Chandelier with Fabric Shade

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

51033 51034 51037 51113 51114 51115

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take

care not to lose any small parts necessary for installation.

3. Slide the electrical wires through the tube(F)/(E)/(D)/(C) and canopy(A) .

4. Raise the tube (F) to top screw pipe of shade (H), raise the tube (E) ,tube

(D) ,tube (C) to the screw pipe nipple in order , then by turning it clockwise until

tight. Open the link(B), hooked the canopy(A) and the end loop of lamp body,

close the link(B).

5. Install the light bulbs(Not included) in accordance with the fixture specifications.

NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

6. Please see the Fig 1.1 (round frame Top View). Loosen the tie crystal

cluster of cord and organize appropriate. Raise the acrylic plate(I), round frame

(J) to the bottom of the lamp body (H), aligning the center hole with pipe nipple

and screw it with the finial (M).

7. Thread the two mounting screws into the pre-drilled holes in the Mounting plate

spaced the same distance apart as the holes in the canopy (A).

8. Attach the Mounting plate to the Junction Box with the two Junction Box screws

as shown. The side of the Mounting plate marked "GND" must face to out. The

junction box is not include.

9. While holding the fixture lamp towards the ceiling , connect the electrical wires

as Shown in Fig.2, making sure that all wire nuts are secured. You may have to

wrap the connections with electrical tape. If your outlet has a ground wire (green

or bare copper), connect the fixture ground wire to it. Otherwise connect

fixture’s ground wire directly to the Mounting plate with the green screw

provided. After wires are connected, tuck them carefully inside the Junction

Box.

10. Raise the canopy (A) on to the Junction box, aligning screws on mounting

plate with mounting holes in canopy and lock it securely with the ball nuts.

11. Raise the end grapnel of the crystal cluster(K) hooked the middle ring of round

frame(J); raise the end grapnel of the crystal cluster(L) hooked the inside ring

of round frame(J); raise the end grapnel of the crystal cluster(G) hooked the

side hole of tube(F).

Your installation is now complete. Return power to the junction

box and test the fixture.

Mounting plate

Mounting screw

Fixture

Junction Box

(Not include)

Ground Wire

Middle

ring

Inside

ring

Fig 1.1

Round

frame(

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us online at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1