User's Manual

BlueAnt

Basic Headset Functions

For easy reference, also see the Button/Function Matrix and the Quick Start Guide.

1. Power ON: Press and Hold the BAB

for 3 seconds. The solid Blue LED will light up. If the battery is low a solid Red LED

will be displayed. After powering ON, your headset will automatically connect to your last used phone if it is in operating

range. If this phone is not range, the V1 will enter idle mode after 60 seconds. If no phone has yet been Paired, it will enter

the welcome prompt.

2. Power OFF: Press and Hold the BAB

for 3 seconds. The Red LED ﬂ ashes three times. Power Off works on Standby/

Idle mode.

3. Enter Pairing Mode: With the V1 OFF, Press and Hold the BAB for about 6 seconds until the LED ﬂ ashes Blue. The V1 will

stay in pairing mode for 2 minutes then will go into idle mode. To re-enter pairing mode, repeat this step, or say “Pair Me”

4. Make a Call: Dial the number using your phones keypad as normal. Audio will automatically transfer to the headset.

5. To Answer a call: Click the BAB

once when there is an incoming call.

6. To End a call: Double Click the BAB to end the call.

7. Reject: Double Click the BAB

to reject an incoming call.

8. Redial the last call : Press and Hold Vol

for about 3 seconds. To cancel Redial, click the BAB

9. Activate Phone Commands (Voice Dialling)*: While connected to a phone, press the BAB once. Voice commands must

have been previously recorded into your phone (see your phones user guide for speciﬁ c instructions. (Button Only Mode)

10. Reconnect: To reconnect your phone to the V1, simply turn the V1 ON. Or if already powered ON, Click Volume and

Volume

together. Alternatively, you can use the menu of your Bluetooth phone.