Operation Manual

■ Before connecting an appliance to the generator, check that it is in good

order, and that its electrical rating does not exceed that of the generator.

Then connect the power cord of the appliance, and start the engine.

NOTE:

■ When an electric motor is started, both the overload indicator light (red) and

the output indicator light (green) may go on simultaneously. This is normal if

the overload indicator light (red) goes off after about four (4) seconds. If the

overload indicator light (red) stays on, consult your generator dealer.

1. Connect the ground terminal.

2. Start each engine according to "STARTING THE ENGINE".

When the output indicator light (green) does not light and the overload indicator

light (red) lights instead, set the engine switch to STOP, stop the engine at once

and then start the engine again.

3. Confirm that the equipment to be used is switched off, and insert the plug of

the equipment to be used into the AC receptacle of unit A or unit B.

CAUTION