User Guide

ManualsBrandsLochinvar ManualsBoilers257,000 BTU Output Two Stage Spark Ignition Copper-Fin Boiler (LP Gas)

2 Operating instructions (continued)

User’s Information Manual

Pilot Location

Main Burner

TOP OF FLAME SPREADER TO BE

FLUSH WITH TOP OF BURNER

Figure 2-2_Pilot Location

9. Turn the control knob on the gas valve coun ter clock wise

to the “PILOT” position.

USE A FIELD SUPPLIED LIGHTER OR THE

FACTORY SUPPLIED LIGHTING WAND TO

LIGHT THE STANDING PILOT

Figure 2-3_Lighting Wand

NOTICE

The information package shipped

with the appliance contains a wire

lighting wand. The loop end of the

wand will hold a match. The wand

extends your reach to the pilot and

makes lighting the pilot easier (see

FIG. 2-3).

10. Use the loop end of the wire lighting wand, shipped

with the instruction pack age, to hold the match and

reach the pi lot. An access slot is provided in the lower

front jacket panel, beside the burner, to insert the

lighting wand and match to the pilot. Lift the pilot cover

(FIG. 2-3) to access the pilot. Push down and hold in

the red button on the gas valve. This should start gas

flow to the pilot. Con tin ue to hold the red button in for

about one (1) minute after the pilot is lit. Release the

button and it will pop back up. The pilot should remain

lit. If the pilot goes out, repeat steps 5 through 10.

If the red button does not pop up when re leased, stop

and immediately call your gas supplier.

If the pilot will not stay lit after sev er al tries, turn the gas

control to “OFF” and call your service technician or gas

supplier.

11. Turn the gas control knob on the gas valve

counterclockwise to the “ON” position.

12. Turn on all electric power to the appliance.

13. Re-install the lower panel door.

14. Set the thermostat to the desired setting.

15. Re-install the control panel door.

TO TURN OFF GAS TO APPLIANCE

1. Set the thermostat to the OFF position.

2. Turn off all electric power to the appliance if service is to

be performed.

3. Turn the gas control knob on the gas valve clockwise to

the “OFF” position. Do not force.

 WARNING

Should overheating occur or the gas fail

to shut off, turn off the external manual

gas valve to the appliance.