Installation Instructions

Tools Typically Required:

Utility knife, caulking gun, masking tape and tooling device.

Safety Precautions:

Apply and cure in a well-ventilated area. Wear gloves and wash hands after use.

Preparation:

Apply sealant between 40°F (5°C) and 100°F (38°C). Surfaces must be clean, dry and free of old caulk, grease, dust and other

contaminants. Remove mold or mildew using bleach and detergent that does not contain ammonia. Rinse surface and allow to dry.

For neat bead lines, mask both sides of the joint. Cut the tip off the cartridge or squeeze tube at a 45° angle to desired bead size

(minimum of 3 mm or 1/8”).

Application:

Using caulking gun, apply sealant with steady pressure, forcing the sealant into the joint. Smooth bead immediately with a wet finger

or a tool. Remove masking tape immediately after tooling and wipe excess off of hands and tools. Sealant is paintable within 20

minutes depending on temperature and humidity. Allow at least 24 hours before exposing to water.

Clean-up:

Clean tools and uncured product residue immediately with warm, soapy water. Cured sealant may be carefully cut away with a

sharp-edged tool.

PAGE 1
Tools Typically Required: Utility knife, caulking gun, masking tape and tooling device. Safety Precautions: Apply and cure in a well-ventilated area. Wear gloves and wash hands after use. Preparation: Apply sealant between 40°F (5°C) and 100°F (38°C). Surfaces must be clean, dry and free of old caulk, grease, dust and other contaminants. Remove mold or mildew using bleach and detergent that does not contain ammonia. Rinse surface and allow to dry. For neat bead lines, mask both sides of the joint.