User`s manual

transfer mode option for the Device Server, move the

DIP Switch 1 to OFF position.

You can assign the TCP port number to monitor and

access the serial device via device server over the

network/Internet from a workstation using Serial IP

Redirector software. (The TCP port number can be of

any number from 1024 to 65535).

RS-232/422/485 Transfer Configuration

In case you are using a serial device with 2-wire RS-

485 application or Modbus RTU protocol, do not forget

to “Enable” Packet mode of serial input. Also put

appropriate inter-packet timeout value to allow the

smooth data communication.

To add the time-out value via console mode, first

“Enable” the packet mode and “Save” the settings.

Once settings applied, you will be able to change the

timeout value.