Dining Set
Care and Maintenance Instructions Keeping Your Furniture Beautiful Quality furniture is a significant investment expected to last for generations. To maintain its beauty and help it last, furniture needs the right care. No finish is totally indestructible. But with regular care, the finish will last much longer, providing years of enjoyment to you. Tips to Protect and Care for Your Furniture 1. Avoid placing your furniture in direct sunlight, as sunlight causes fading. 2.
Leather Furniture Care: Wipe spills immediately with clean cloth or sponge. For spots or stains and daily cleaning, clean with mild non-detergent soap. Rinse well, gently wipe off, and allow to air dry. Cleaning Butter, Oil or Grease from Leather: Wipe leather with a clean cloth, and leave alone. The oil will be absorbed by the leather. DO NOT APPLY WATER. Also, do not use saddle soap, cleaning solvents, furniture polish, oils, varnish, abrasive cleaners, ammonia or any other type of chemical solution.
again. Pour out a small amount of oil, and rub it into the wood using a cloth or paper towel. As the oil soaks in, add more and continue rubbing and polishing with the grain until the oil is absorbed. The first time you seal your butcher block, it may take several applications before it stops "drinking" oil, but in later cleanings you'll just need to refresh it. Keep adding oil until no more soaks in, remove any excess with a cloth.
PART LIST A 0 B D C E � Table Legs Top Shelf 1 PC 2 PCS 1 PC Bottom Shelf Back Leg Table Bottom Rail 1 PC 1 PC 1 PC Top Panel L H M � � Inner Wine Rack Outer Wine Rack 2 PCS Glass Holder N 2 PCS J 2 PCS Glass Shelf 1 PC � Seat Panel Chair Top Rail Chair Legs Chair Bottom Rail 2 PCS 4 PCS 4 PCS 4 PCS HARDWARE LIST ✓ ;> 04mm*1-1/4" 04mm*1-3/4" 04mm Screw Long Screw Allen Key � 01/4"*13mm Bolt 27 PCS(Extra 1) 9 PCS(Extra 1) 17 PCS(Extra 1) 1 PC 0 10mm Pad
Step 1. Attach table legs (part B) to top panel (part A) by using bolts (part #1) and allen key (part #4 ). Note: Please do not fully tighten bolts until unit is fully assembled. B #1 @a x4 #4 � x1 Step 2. Attach glass holders (part I) to table legs (part B) by using bolts (part #1) and allen key (part #4 ).
