Installation Guide

problem
reason
Solution
There is no
water in the
nozzle
Blockage caused by bent water
inlet hose
Inlet valve closed
Water supply cut off
The water inlet hose is bent, causing
partial blockage
Inlet valve not fully open
Inlet filter clogged
Set the water temperature to the
normal temperature level
The valve seat temperature is set
at the normal temperature level
If the above method still cannot solve the problem, please turn off the power
and contact the service provider for repair.
If the leakage circuit breaker frequently trips, it indicates that the product has
leakage. Please turn off the power and contact the service provider for repair.
Remote control
cannot display
The spray rod
cannot extend
The spray
rod cannot
be retracted
no wind
Low wind
temperature
Low valve
seat temperature
water
temperature
is low
Weak water
cleaning
Solve the problem of water inlet
hose bending
Open the inlet valve
Press the water supply system and
wait for water supply
Solve the problem of water inlet hose
bending
Fully open the inlet valve
Clean the filter
Reset water temperature
Reset seat temperature
Adjust to reach the sensing area
Switch to feature mode and use it
for 3 minutes before using it
Set the wind temperature at the
normal temperature level
In standby mode or power saving
mode
power failure
Stuck by impurities
power failure
Not sitting in the sensing area
Reverse the polarity of the battery
Reset wind temperature
Switch to feature mode to use dry
function
Gently push the spray bar back
Clear impurities
restart
Sitting in the sensing area
Replace the battery again
warn
！
11
Handling methods for cover plate faults
In standby mode