Installation Guide

Important safety instructions
！
！
13
Attention - Failure to follow the instructions may result in physical injury or property damage.
1. Do not install or use this product in damp areas such as steam rooms.
2. It is recommended to use a waterproof power socket and install it in a place that is not easily affected by
moisture.
3. This product is only suitable for currents of 110V-120V, 50/60Hz, with a load current of at least 15A. The
power plug must be equipped with a ground fault circuit breaker or ground fault leakage protector or similar
high sensitivity, fast type leakage switch (rated sensitive current below 6mA).
4. When lightning strikes, it is strongly recommended to unplug the power plug.
5. Do not stand on a ceramic toilet.
6. Ceramic bathrooms must be equipped with floor fixing bolts.
7. Do not stand on product units, seats, or covers.
8. When using this product, do not lean against the seat cover to avoid damage.
9. This product is equipped with a soft closing sealing cover. Pressing or pushing hard may damage the soft
closing damper.
10. Do not use paint thinners, gasoline, liquids, cleaning agents, insecticides, toilet cleaners, and drama
cleaning products.
11. Do not expose to direct sunlight.
12. Only tap water or drinking water should be used, otherwise it may cause scratches.
13. Do not connect the outlet of the water heater to the water heater. Ensure that the inlet water temperature
is between 3-35℃/37.4-95℉.
14. When the room temperature is below zero, please dry the water tank to avoid freezing.
15. Increase the temperature of the rest room to prevent damage to the toilet due to freezing.
16. When moving the product from a cold or humid environment to normal room temperature, wait for 2 hours
until the condensate has completely evaporated. This can prevent electrical short circuits in the product.
17. When the product is not used for more than three (3) days, drain the water from the container and unplug
the power plug from the wall socket.
18. When the product malfunctions, please stop using and turn off the power. Please contact service
personnel for professional repair.
ground indication
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing a current escape wire.
This product is equipped with a grounding wire with a grounding plug. The plug must be inserted into a
properly installed and grounded socket.
Danger - Improper use of grounding plugs may lead to electric shock hazards.
If it is necessary to repair or replace the power cord or plug, please do not connect the grounding wire to any
flat blade terminal. The outer surface of the insulated wire is green, with or without yellow stripes as the
grounding wire.
This product is shipped with specific wires and plugs to allow connection to appropriate circuits. Ensure that
the product is connected to the same socket configuration as the plug. This product should not use any
adapters. Do not modify the provided plug. If it is not suitable for the socket, please have a qualified
electrician install the appropriate socket. If the product must be reconnected for use on different types of
circuits, reconnection should be carried out by qualified service personnel.
Save these instructions