User's Manual

Using the Main Menu14
5. Choose how the system will react when the selected event occurs:
• Show Message: Error message will appear on the recorder’s display.
• Record Channel: For Net Disconnection events only. Select the numbered tiles next to
this option to record video from the corresponding channels. Set the length of recording
following a network disconnection event in the Post_REC field.
• Buzzer: The recorder will sound an audible alarm.
• Send Email: Send an email notification with details on the event (requires email configura-
tion — see 14.6.3 Configuring Email Alerts, page 61 for details).
6. Click Apply.
14.3 Backup
See chapter 10 Backup, page 29 for details.
14.4 Display
Set the system’s monitor resolution, configure Sequence mode, and other display settings.
14.4.1 Setting the Recorder’s Output Resolution
The first time you power up the system and complete the Lorex Setup Wizard, the system will au-
tomatically match the resolution of the connected monitor. You can set the recorder to a different
output resolution at any time.
CAUTION
If you need to switch the monitor used with the system, make sure you set the recorder to an output resolution sup-
ported by the new monitor before switching.
To change the output resolution:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click DISPLAY, then click the DISPLAY tab.
3. Set the resolution to match the highest resolution supported by your monitor. For example, se-
lect 3840×2160 for 4K monitors, or 1920×1080 for 1080p.
4. Click Apply. The recorder will restart before changes take effect.
14.4.2 Listen–In Audio
Enable and set volume for camera audio feeds in the Live View display.
#LX400111; r. 1.0/55872/56018; en-US 52