User's Manual
Table Of Contents
- 1 Important Safeguards
- 2 Package Contents
- 3 Recorder Overview
- 4 Basic System Setup
- 5 Camera Installation
- 6 Using the Mouse
- 7 Using the On–Screen Display
- 8 Recording
- 9 Playback
- 10 Backup
- 11 Motion Detection
- 12 Active Deterrence
- 13 Managing Passwords and User Accounts
- 14 Using the Main Menu
- 14.1 Playback
- 14.2 Alarm
- 14.3 Backup
- 14.4 Display
- 14.5 Camera
- 14.6 Network
- 14.7 System
- 14.7.1 Configuring General System Settings
- 14.7.2 Setting Date & Time
- 14.7.3 Configuring Holidays
- 14.7.4 Configuring IP Filter
- 14.7.5 Save System Settings to a USB Flash Drive
- 14.7.6 Import System Settings from a USB Flash Drive
- 14.7.7 Restoring Default Settings
- 14.7.8 Upgrading Firmware Manually
- 14.7.9 Automatic Firmware Upgrades
- 14.8 Storage
- 14.9 Account
- 14.10 Information
- 14.11 Copying Settings to Another Channel
- 15 Connecting Remotely using the Lorex Home Mobile App
- 16 Smart Home & Voice Assistance
- 17 Pan/Tilt/Zoom (PTZ) Cameras
- 18 Connecting Audio Devices
- 19 Replacing the Hard Drive
- 20 DDNS Setup (Advanced)
- 21 Troubleshooting
- 22 Technical Specifications
- 23 Notices
Pan/Tilt/Zoom (PTZ) Cameras17
To add patterns:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click Pan/Tilt/Zoom.
2. The PTZ controls open. Click
to open advanced PTZ controls, then click .
3. Click the Pattern tab.
4. Under Pattern, enter the number of the pattern you want to create.
5. Move the camera to the desired starting position, then click Start.
6. Using the on-screen controls, move the camera in any pattern you wish. When finished, click
End.
To run a pattern:
• Under No., select the number of the pattern you want to go to, then click
.
17.7 AutoScan
An autoscan automatically cycles between a left and right point.
To configure autoscan:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click Pan/Tilt/Zoom.
2. The PTZ controls open. Click
to open advanced PTZ controls, then click .
3. Click the Border tab.
4. Move the camera into the desired left position and click Left.
5. Move the camera into the desired right position and click Right.
To run autoscan:
• Click
.
#LX400111; r. 1.0/55872/56018; en-US 86