Lowel Blender™ Instructions Intuitive LED Lighting LOWEL ™
Warnings Blender Technical Data ™ The Lowel Blender is a professional AC/DC powered lighting fixture. Read these instructions before operating. Weight, Blender Light Alone: 1.2 lbs (544 g) n Not for house hold use, use only for professional imaging purposes. n Do not immerse unit in water or use in damp locations. n Do not obstruct heat ventilation for unit. n Do not stare directly into LED’s. n Do not leave unit unattended. n Always use clear plastic front guard.
Front Diffusers Blender comes with a set of textured front accessory diffusers that can vary the light quality, while diffusing it to help prevent multi-shadows at close distances. The standard is Lite Frost. Also included are Prismatic, & Cracked Ice. There are 2 sets of grooved slots in the front of the Blender to hold these. A clear plastic front guard is also supplied, to protect the LED’s. It should be used in the slot closest to the lamps.
Powering the Lowel Blender™ AC Adaptor auto-sets from 120 - 240v. AC cable plug must be correct for incoming voltage. A 2 pin Euro plug cable is provided, and can be easliy swapped. Other international AC cables are available at most electronics stores. 12 Volt Battery Cables (5 ft.) Code Cable Connector BL-85 Cigarette Plug Cable BL-82 4-Pin XLR Cable BL-83 Anton Bauer D-Tap Lowel-Light Manufacturing, Inc. 90 Oser Avenue, Hauppauge, NY, 11788 Call: 800 645-2522 631 273-2500 www.lowel.