User Guide

DSC SETUP
USER MMSI
GROUP SETUP
►ATIS MMSI
ATIS SELEC▼
INPUT ATIS
MMSI
9
ATIS MMSI
9987654321
►STORE
CANCEL
ATIS MMSI
INPUT AGAIN
9
ATIS MMSI
9987654321
►STORE
CANCEL
2. If this is the rst time that you are entering your ATIS MMSI, a dashed line appears.
Enter your ATIS MMSI along the dashed line. The first number is always 9. Press ENT to
confirm each correct entry and to move to the next digit.
If you make an error, press – until < appears then press ENT to backup and correct the
entry.
3. Press ENT to store the ATIS MMS.
4. Enter your ATIS MMSI again as a password check, then press ENT to permanently store
the ATIS MMSI and return to the menu.
5. You can view your stored ATIS MMSI at any time by selecting ATIS MMSI in the main
menu.
5-4 Enable ATIS functionality (ATIS SELECT)
EU models only.
ATIS functionality will operate only after the ATIS MMSI has been entered (see previous section).
When ATIS functionality is enabled, the ATIS symbol
ATIS
is shown on the LCD.
DSC SETUP
GROUP SETUP
ATIS MMSI
►ATIS SELECT
INDIV REPL▼
ATIS SELECT
►ON
OFF
1. Select DSC SETUP then ATIS SELECT.
2. Select OFF to disable ATIS functionality or select ON to enable the ATIS functionality -
DSC must be turned off first.
3. Press ENT to confirm.
Note: It is not possible to have both ATIS ON (on) and DSC ON (on) simultaneously. If you
want to activate ATIS, you must first switch DSC off. A warning will remind you if DSC is
already ON.
Lowrance - Link-8 Operation Instructions 39