Installation Instructions

14
2. Slip the clamp around the trolling motor, as
shown below. Tighten the hose clamp securely to
the trolling motor.
1. Slide the hose clamp
through the Pod transducer
brackets, as shown below.
Hose
clamp
Hose
clamp
Cable ties Cable ties
Transducer
The top of the
transducer is
curved to t
the contour
of the trolling
motor.
You will need a hose clamp large enough to
t over the trolling motor. The hose clamp
is NOT included with the Pod transducer.
Before you attach the transducer to the
trolling motor, make sure there is enough
slack in the transducer cable for the trolling
motor to turn freely.
Pod Transducer trolling motor installation
The transducer should be mounted ahead of the trolling motor n. Position
the transducer to so its face is pointing straight down when the trolling motor
is in the water.
Route the transducer cable along the trolling motor shaft. Use plastic ties
(not included) to secure the cable to the shaft.