Installation Instructions

16
The unit comes with a gimbal bracket so you can mount it on a dash. The unit also
ships with an in-dash template and four screws for in-dash installations. Determine
the mounting location for the unit. Screws to secure the gimbal bracket to a dash are
not included with the unit.
Gimbal bracket installation
Holes in the gimbal bracket’s base allow for wood screw or through-bolt mounting.
When mounting the unit using the gimbal bracket, make sure there is enough clear-
ance behind the unit to allow for tilting of the unit and connection of the various
cables.
NOTE: Before beginning any installation, read the
following instructions carefully and double check all
cable lengths to make sure the cables will reach the
power source, unit, GPS antenna-receiver module,
transducer, etc.
1. Use the gimbal bracket as a template
and mark the mounting holes, including
the center hole for the cables.
2. Drill a 1-inch (25.4 mm) hole for the sonar, power/data, Ethernet and network
cables. The large center hole in the gimbal bracket will be used to pass these
cables through.
The gimbal bracket arms
should slope toward the
front of the unit.
Mounting the Unit: Gimbal bracket or In-dash