Installation Instructions

19
In-dash installation
The unit ships with an in-dash template and four #6 – 20 X 1-1/2" screws. Before
cutting any holes in the mounting surface make sure there is enough room to attach
the cable connectors behind the unit. Begin by taping the in-dash template to the
mounting surface.
The template included with your unit will have the proper measurements writ-
ten on it, including the size of the hole saw to use to drill the corner holes
shown in the following step. Cut only on the dotted lines indicated by the
template.
The four corner holes
are indicated by these
shaded areas.
Use a hole saw to drill the four corner holes indicated by the shaded areas
on the template above. Using a hole saw to cut the four corners will ensure
smoother, and more rounded, corners for the in-dash installation.
Use a #31 (0.120") drill bit
for the four pilot holes.