Installation Instructions

2. Aligning Ratchets on Transducer bracket

Aligning ratchets on one-piece bracket:

The one-piece bracket assembly includes two black plastic ratchets. The ratchets

are used to align the transducer with the boat hull. Each ratchet has the letters A-E

molded into it.

If the transducer will not adjust with its face parallel to the ground, remove the

transducer and ratchets from the bracket. Reinsert the ratchets into the bracket, this

time with the letter "B" aligned with the dot stamped in the bracket. Reassemble the

transducer and bracket and place it against the transom. Again, check to see if the

transducer will adjust so its face is parallel with the ground. Repeat this process until

the transducers face will adjust so that it is parallel with the ground.

3. Hold the transducer assembly

against the transom. Look at the

transducer from the side. Try to

adjust the transducer so its face

is parallel to the ground. If it does,

then the "A" position is correct.

Transom

2. Slide the transducer in the

bracket and temporarily slide

the bolt through the transducer

bracket, as shown in the image

at right.

1. Insert the ratchets in the bracket with the letter

"A" aligned with the dot stamped on the outside

of the transducer bracket, as shown in the fol-

lowing series of diagrams.

Ratchet

Bracket

Align dot and

letter "A".