Installation Instructions

Aligning ratchets on two-piece bracket:

The two-piece bracket includes four black plastic ratchets. The ratch-

ets are used to align the transducer with the boat hull. Each ratchet has

the letters A-F molded into it.

If the transducer will not adjust with its

face parallel to the ground, remove the

transducer and ratchets from the brack-

et. Reinsert the ratchets into the bracket,

this time with the letter "B" aligned with

the dot stamped in the bracket. Reassemble the transducer and bracket and place it

against the transom. Again, check to see if the transducer will adjust so its face is

parallel with the ground. Repeat this process until the transducers face will adjust so

that it is parallel with the ground.

1. Place two of the ratchets in each side of the bracket

with the letter "A" aligned with the alignment mark molded

into each bracket.

2. Now place the other two ratchets on

the transducer with the letter "A" aligned

in the 12 o'clock position on the trans-

ducer stem.

Ratchet

Bracket

Alignment

mark

4. Hold the transducer assembly

against the transom. Look at the

transducer from the side. Try to

adjust the transducer so its face

is parallel to the ground. If it does,

then the "A" position is correct.

3. Slide the transducer in the bracket

and temporarily slide the bolt through

the transducer bracket.

Transom