Installation Instructions

4. Aligning and Attaching the Transducer on the Transom

Adjust the transducer so that its "face" is parallel with the ground and its center line

is even with the bottom of the boat hull.

When mounting the transducer to the transom, there are two extremes you

should avoid, rst, do not let the edge of the mounting bracket extend below

the bottom of the hull, left image, above. Second, do not let the bottom of the

transducer rise above the bottom of the hull, right image, above.

The center line of the transducer

should be level with the bottom of

the boat hull and its "face" parallel

with the ground.

Transom

Bottom of hull.

Transducer face

Transducer bracket

mounted too low.

Bottom of hull.

Transom

Transducer bracket

mounted too high.

For single frequency

transducers, with a

one-piece bracket,

assemble it with the

cable passing over

the bolt and through

the bracket, as shown

here.

Do not over tighten

the transducer bracket

lock nut. If you do, the

transducer may not

"kick-up" if it strikes an

object in the water.