Installation Instructions

7
Use the provided screws to secure the transducer assembly to the transom.
1. Hold the transducer and brack-
et assembly against the transom.
When the transducer and bracket
are properly aligned mark its posi-
tion on the hull.
2. Drill the mounting holes for the
transducer bracket. For the one-
piece bracket use a #29 bit (for
the #10 screws). For the two-piece
bracket use a #20 bit (for the #12
screws).
Clamp the transducer cable to
the transom near the transducer.
This will help keep the cable
secure.
If you drill a hole in the transom
for the transducer cable, make
sure it is located above the
waterline. Seal the hole with
an above- or below-waterline
marine grade sealant.
Water line
When mounting a Skimmer transducer
to a boat with a veehull, make sure the
transducer center line is aligned to the
bottom of the boat hull, as shown here.
Be sure to use a below-waterline
marine grade sealant on all of the
transducer bracket screw holes.