Installation Instructions

The TMB-S bracket is designed for one-piece bracket transducers only.

The TMB-S trolling motor bracket (Part No. 51-45) is an optional accessory and is

available through LEI Extras at www.lei-extras.com. The TMB-S bracket is used

to attach a one-piece bracket transducer to a trolling motor. If you regularly sh in

water with a lot of underwater structure, such as rocks, stumps and trees, you may

consider using a Pod transducer for trolling motor installation. Pod transducers can-

not be "kicked up" by underwater structure.

Using the components supplied with the TMB-S bracket (adjustable strap, in-

ternal tooth washer and plastic bracket) attach it to the transducer as shown

in the diagram above.

Slide the adjustable strap through the plastic bracket as shown above, left,

then slip the strap around the trolling motor as shown in the image, at right.

Position the transducer so its "face" is pointing straight down when the troll-

ing motor is in the water. Tighten the adjustable strap securely to the trolling

motor. Make sure there is enough slack in the transducer cable for the trolling

motor to turn freely.

Adjustable strap

Route the transducer ca-

ble along the trolling mo-

tor shaft. Use plastic ties

(not included) to secure

the cable to the shaft.

Flat washer

Lock nut

Bolt

Internal tooth washer

Plastic bracket

TMB-S trolling motor bracket installation