Installation & Assembly
Tools Needed
You will need a Pencil, Phillips head screwdriver, Tape measure,
Drill, Assorted Drill bits (5/16” & 3/8”), 1/2” socket ratchet,
4ft Level, Rubber mallet and Safety glasses.
NOTE:
It is very important to determine whether you will be installing
a Mounting Board prior to installing the track. If you do need to
install a Mounting Board, it MUST be installed rst.
(Mounting Board Not Included)
Montana Door Assembly and Track Installation
Please read ALL instructions before you begin installation.
You MUST determine if you need a Mounting Board prior to doing ANY installation. Due to many overlapping factors
such as the location of wall studs, the weight of a Barn door and the various types of trim used in homes, we
recommend using a Mounting Board in all situations. Track must be installed into Solid Blocking or Head Casing.
3. Attach U Clips to
Door Stiles
Make sure the wider channel in
the stile with the larger holes is
facing to the outside. Make sure
the larger holes in the U clip are
facing to the inside of the stile and
insert the U clip (G) into the end
of a Stile (A). The top of the U
clip will rest on the top of the Stile
once inserted. Take 2 of the U clip
screws (Q) and using the Phillips
head screwdriver, secure the U clip
to the Stile. Hand-tighten only and
do not over tighten. Repeat with
the other Stile, U Clip and screws.
NOTE NOTE
1. Attach Screw Sleeves to Rails
Take the Top Rail (B) and attach the 4 Top screw sleeves (F1) to
the metal brackets. Hand-tighten only. Do not over-tighten. Take
the Center rail (C) and Bottom rail (B) and attach the 6 Center/
Bottom screw sleeves (F2) to the metal brackets. Again,
Hand-tighten only. Do not over-tighten. Set the Rails aside.
Top Rail (B)
Center Rail (C)
Bottom Rail (B)
F1
F2
2. Remove Finishing Strips
Take the 2 Door Stiles (A) and
remove the nishing strips (E) from
the outer stile channels. Set the
strips aside.
4. Attach Roller brackets
Take one of the Roller brackets (O) and
2 of the Allen screws (Y) and secure
to the U clip (G) with the Allen wrench.
Repeat with the other Roller Bracket.
F2
A
E