Owner's Manual

1. Lay out door planks A, Bs, C on a flat surface.

assemble the door slab by fitting T&G. Make sure the top

and bottom ends are flush. Adjust T&G spacing to get the

correct width.Check to make sure the door slab is sqaure

2.Lay out overlay planks and insert screws into the pilot holes.

Don’t overtight the screws. Press the boards together

closely without gaps when tightening the screws.

3. Repeat the step on the other side.

4. We recommend to sand the surface before stain the door.

Test stains or paints on scraps first.

Before Assembly

LUBANN Wooden Barn doors have unique rustic appearances coming from the following natural characters of alder wood.

Open and closed knots sizes will vary from pinhole knots to over an inch wide open knots

Bark Pockets – bark that is partly or completely enclosed in the board

Checking – surfaced stress cracks going across the grain mainly caused by seasoning

Shake – separation along the grain

If any door plank(s) arrive(s) showing warping, bowing or cupping that may cause the door assembly unnecessarily difficult,

please contact us immediately and we will replace warped and damaged pieces.

●

A quick guide to assembly

2a 2b

1 1/2 inches

3/4 inches

28-42 inches

84 inches

30 inches

84 inches

x30