Instructions / Assembly

Climate II Installation Instructions

7 | P a g e

USING YOUR CEILING FAN

Pairing Transmitter and Receiver – when 2 or more DC ceiling fans are installed in one location

When two or more fans are located near each other, you may want to have the receiver/transmitter for each

fan set to a different code, so that the operation of one fan does not affect the operation of the other fan/s.

The DIP switches for the transmitter (remote hand piece) are located in the battery compartment of the

transmitter. Configuring the DIP switches will allow a unique transmission code assigned to each fan ceiling.

NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.

NOTE: Ensure power to the receiver is ON prior to pairing the transmitter with the receiver.

Transmitter / Receiver pairing for Ceiling fan 1:

⚫ Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.

⚫ Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.

Fig.12

⚫ Change the position of the DIP switches in the transmitter 1, so that it will be different to transmitter 2.

⚫ Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own

isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).

⚫ Press and hold the “SET” button of transmitter 1 for 6 seconds within 60 seconds of switching the power

ON to the receiver of ceiling fan 1.

While pairing the DC fan remote and receiver is in process, the fan will automatically start to rotate in the

counterclockwise direction and on the highest RPM for 3 minutes. When counterclockwise rotation has

finished, the fan will automatically reverse to clockwise direction again to the highest RPM for 3 minutes.

Fan will turn off when the pairing process has finished. During the pairing process, the remote is non-

functional.

⚫ Turn ON and change the speed of the ceiling fan 1 by the transmitter 1 to check the operation and

successful pairing.

Transmitter / Receiver pairing for Ceiling fan 2:

⚫ Turn off the mains supply to the receivers of both ceiling fans 1 and 2.

⚫ Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.

Fig.12

⚫ Change the position of the DIP switches in the transmitter 2, so that it will be different to transmitter 1.

⚫ Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own