Instructions / Assembly

Climate II Installation Instructions
8 | P a g e
⚫ Turn ON and change the speed of ceiling fan 2 by the transmitter 2 to check the operation and successful
pairing.
Note: The pairing of the transmitter and receiver is not required if only one ceiling fan is installed.
When more than two ceiling fans are installed near each other, please refer to the instruction above.
Remote Control Buttons
A - FAN SPEED CONTROL BUTTONS:
There are 6 available speeds. “I” button is for the lowest speed, and “VI”
button is for the fastest speed.
NOTE: when you turn on the fan for the first time or switch the main power to
the controller, you need to start the fan on high “VI” speed first and then
choose a lower speed. 5-10 seconds is required to allow the DC fan to
respond to the remote for each speed or fan direction selections.
B - FAN OFF BUTTON:
Press the button to turn the fan OFF.
C - REVERSE FUNCTION BUTTON:
Press the button to activate the reverse running function. The fan must be
operating to activate the reverse function.
D - LIGHT CONTROL BUTTON: (Light kit sold separately)
Press the button to turn the light ON/OFF.
Press and hold the button to access the light dimming function.
E – D / ON SWITCH
This switch marked D/ON controls the dimming function of the lights. If using
non-dimmable bulbs, use a ballpoint pen or small screwdriver to set the switch
to “ON” to disable the dimming function. If using dimmable halogen bulbs, set
the switch to “D” to enable the dimming function. Fig. 14
THE RECEIVER PROVIDES THE FOLLOWING LEVEL OF PROTECTION:
⚫ Lock position: the receiver has a built in safety feature to protect against obstruction during operation.
The motor will be locked from operation and will disconnect from power after 30 seconds of interruption.
Please remove obstacles before re-starting. To reset, simply turn off the power supply to the fan motor
and re-start.
⚫ Over 80W protection: when the receiver detects power consumption which is greater than 80W, the
receiver power will be stopped and operation will immediately discontinue. Turn the receiver power on
after 5 seconds to restart the fan.
Fig. 12
Fig. 13
Fig. 14