qrtitle.
qrtitle.book Page ii Friday, December 18, 1998 9:52 AM DE Copyright © 1999 by Lucent Technologies. All rights reserved. DEFINITY, MERLIN, MERLIN LEGEND and PARTNER are registered trademarks of Lucent Technologies. The order number for this book is 503-801-165. To order additional copies of this book, call 1 800 457-1235 or 317-322-6791.
qrtitle.book Page iii Friday, December 18, 1998 9:52 AM Contents Quick Reference 1 Handset Controls . . . . . . . . . . . Handset Display . . . . . . . . . . . . Line Status Indicators . . . . . . . . . Volume Adjustment . . . . . . . . . . Battery Charger LEDs . . . . . . . . . Help! . . . . . . . . . . . . . . . . . . Making a Call . . . . . . . . . . . . . Answering a Call. . . . . . . . . . . . Preselecting a Line or Button . . . . . Accessing Certain Voice Mail Systems with a DEFINITY System . . . .
qrtitle.
qrtitle.book Page 1 Friday, December 18, 1998 9:52 AM Quick Reference Handset Controls Receiver Headset On/Off Receives the sound of your caller's voice, unless a headset is connected. Press to turn the headset on if the headset is plugged in. ON appears in handset display. To turn off, press again. Turn on to make or answer a call, and turn off to “hang up.” Antenna Extend fully to maximize the handset range and voice quality. Lanyard Loop Attach lanyard for carrying handset.
qrtitle.
qrtitle.book Page 3 Friday, December 18, 1998 9:52 AM Quick Reference 8 Line Status Indicators show the status of line or programmable/intercom/drop buttons. See “Line Status Indicators” below. 9 Selection rectangle indicates the active row for line or programmable/intercom/drop button selection. When the display is blank, the handset is either turned off or in “sleep” mode. Activate the display by pressing O or " .
qrtitle.book Page 4 Friday, December 18, 1998 9:52 AM Quick Reference Volume Adjustment To increase or decrease the volume of the handset alerter or the receiver (earpiece): • Alerter: Press the “+” or the “-” button while the MDW 9031/9031DCP is awake but turned off. If the display is dark (the phone is in “sleep” mode), press " to wake it up, then press the “+” or the “-” button. • Receiver: Press the “+” or the “-” button while the MDW 9031/9031DCP is turned on.
qrtitle.book Page 5 Friday, December 18, 1998 9:52 AM Quick Reference Battery Charger LEDs The color of the battery charger’s LEDs indicates the state of the corresponding battery pack, as shown in the following table: Battery charger LED shows... If it is the SPARE LED, the battery pack in the Spare battery compartment... If it is the HANDSET LED, the battery pack in the Handset... If it is the REFRESH LED, the Refresh button was pressed, and the Handset battery pack...
qrtitle.book Page 6 Friday, December 18, 1998 9:52 AM Quick Reference Help! MDW 9031 If you need help when using your MDW 9031 with a PARTNER®, MERLIN®, or MERLIN LEGEND® system in the continental U.S., call 1 800 628-2888. MDW 9031DCP If you need help when using your MDW 9031DCP with a DEFINITY® system in the continental U.S., call 1 800 225-7585, or contact the Lucent Customer Care Center at 1 800 241-2121.
qrtitle.book Page 7 Friday, December 18, 1998 9:52 AM Quick Reference Preselecting a Line or Button After Line Preselection is enabled, proceed as follows: 1 If the display is blank, press " . 2 If necessary, press " to move the Selection rectangle. 3 Press ' corresponding to the line or button you want. 4 Press O to access the line or button. Accessing Certain Voice Mail Systems with a DEFINITY System Note: This section only applies to the MDW 9031 Pocket Phone.
qrtitle.book Page 8 Friday, December 18, 1998 9:52 AM Quick Reference Changing Settings or Performing Tests in Local Mode 1 Make sure the handset is turned off. 2 Press and hold " for 3 seconds. 3 While still holding " , press O. 4 Press one of the following: A (2) to enable or disable the alerter. L (5) to enable or disable backlighting. P (7) for 3 seconds, then " to enable or disable Line Preselection. V (8) to enable or disable the vibrator.