Instructions

EN
LUCTRA | 19
English
TABLE PIN
▶see image5
You have following mounting options available for the TABLE PIN(11):
Mounting with a cable hole
The TABLE PIN holds your lamp firmly on any mounting hole ranging from 20 mm to 80 mm.
1. Attach the adhesive foam pad(13) to the upper plate(12).
2. Place the upper plate(12) with the pin and threaded rod(16) from above into the mounting
hole.
3. Screw the lower plate (14) facing upwards onto the threaded rod (16) using a centring
gauge matching the diameter of the mounting hole.
4. Run the power cable through the designated opening(15)
NOTICE!
Risk of damage to the cable!
Do not fasten the TABLE PIN by rotating the lower plate once you have run the power
cable through the designated opening(15).
Otherwise the cable will wrap around the threaded rod and be damaged.
5. Fasten the TABLE PIN by rotating the threaded rod(16). Use the enclosed Allen key to do
this.
6. Place the lamp onto the pin of the TABLE PIN(11).
Mounting without a cable hole
You can fasten your lamp to the TABLE PIN even if the table does not have a cable hole.
NOTICE!
Risk of property damage!
The table top must be at least 25mm thick so that it is not damaged when adjusting
the lamp.
1. Drill a hole in the table top with a minimum diameter of 6.5 mm/maximum diameter of 8
mm.
2. Insert the pin with the threaded rod(16) and washer(17) through the hole from above.
3. Fasten the TABLE PIN by screwing the plate(14) facing upwards to the threaded rod using
the wider centring gauge.
4. Place the lamp onto the pin of the TABLE PIN(11).
Connecting the electrics
▶see image6
1. Connect the connecting cable of the lamp to the power supply unit.
Note:
You must first release the plug lock(18) to disconnect the lamp and power supply unit.
2. Fit the plug appropriate for your mains power network onto the power supply:
– European-style plug(19)
– British-style plug(20)
3. Plug the power supply into the socket.