Instructions
EN
20 | LUCTRA
English
TABLE PRO PIN
▶see image5
You have following mounting options available for the TABLE PRO PIN(11):
Mounting with a cable hole
The TABLE PRO PIN holds your lamp firmly on any mounting hole ranging from 20 mm to 80
mm.
1. Attach the adhesive foam pad(13) to the upper plate(12).
2. Place the upper plate(12) with the pin and threaded rod(16) from above into the mounting
hole.
3. Screw the lower plate (14) facing upwards onto the threaded rod(16) using a centring
gauge matching the diameter of the mounting hole.
4. Run the power cable through the designated opening(15)
NOTICE!
Risk of damage to the cable!
Do not fasten the TABLE PRO PIN by rotating the lower plate once you have run the
power cable through the designated opening(15).
Otherwise the cable will wrap around the threaded rod and be damaged.
5. Fasten the TABLE PRO PIN by rotating the threaded rod(16). Use the enclosed Allen key
to do this.
6. Place the lamp onto the pin of the TABLE PRO PIN(11).
Mounting without a cable hole
You can fasten your lamp to the TABLE PRO PIN even if the table does not have a cable hole.
NOTICE!
Risk of property damage!
The table top must be at least 25mm thick so that it is not damaged when adjusting
the lamp.
1. Drill a hole in the table top with a minimum diameter of 6.5 mm/maximum diameter of 8
mm.
2. Insert the pin with the threaded rod(16) and washer(17) through the hole from above.
3. Fasten the TABLE PRO PIN by screwing the plate(14) facing upwards to the threaded rod
using the wider centring gauge.
4. Place the lamp onto the pin of the TABLE PRO PIN(11).
Connecting the electrics
▶see image6
1. Connect the connecting cable of the lamp to the power supply unit.
Note:
You must first release the plug lock(18) to disconnect the lamp and power supply unit.
2. Connect the power cable that matches the power supply to the power supply unit:
– Power cable with Euro plug(19)
– Power cable with UK plug-in connector(20)
3. Insert the plug into the socket.