Installation Guide

ManualsBrandsLumi ManualsCurtain HardwareDecorative Drapery Hardware Adjustable 1 in. Dia. Double Rod Brackets in Oil Rubbed Bronze Metal (4-Piece)

Place brackets against wall or ceiling at desired locations

and mark screw holes. Use a tape measure and level to make

sure marked screw holes are horizontal to each other.

STEP 4.

Determine projection of brackets. Loosen projection screw,

slide bracket to desire position and tighten projection screw.

Repeat for each bracket.

STEP 3.

Insert the brackets through the screws and gently pull

down to tighten the screw against the narrower portion

of the bracket

key hole.

Pre-drill two pilot holes for each bracket (1/4” drill bit). Screw

anchors into the pilot holes (do not use hammer or tap-in),

and then fasten screws into wall anchors.

STEP 2A. (FOR MOUNTING TO DRYWALL,

CEILING OR PANELING)

Pre-drill two pilot holes for each bracket (1/8” drill bit) and

insert the screws.

STEP 2B. (FOR MOUNTING TO WOOD OR STUDS)

BRACKET INSTALLATION

STEP 5.

STEP 6.

STEP 7.

STEP 8.

ROD INSTALLATION

STEP 9.

FINAL ADJUSTMENT