Installation & Assembly

13
6. Optional Installation of No-Light Plate Assembly
NOTE: To use the No-Light Plate Assembly, the
Light Kit Assembly MUST NOT Be Installed, or Light
Kit Assembly MUST Be Removed.
6.1
Removal of the Shade from the Light Kit Adapter/
Light Kit Assembly:
Rotate the Shade counter-clockwise and remove from
the Light Kit Adapter/Light Kit Assembly (Figure 21).
H
LIGHT KIT
ADAPTER/
LIGHT KIT
ASSEMBLY
SHADE
ROTATE
COUNTER-CLOCKWISE
Figure 21
H
LIGHT KIT
ASSEMBLY
REMOVE ONE PAN
HEAD SCREW WITH
LOCKWASHER
ROTATE
COUNTER-CLOCKWISE
LOOSEN TWO PAN HEAD SCREWS
WITH LOCKWASHERS
Figure 22
6.2
Remove one of the three Pan Head Screws with
Lockwashers in the Light Kit Adapter and loosen the
remaining two screws in the key hole slots (Figure 22).
Rotate the Light Kit Assembly counter-clockwise for
removal.
Replace the screw with lockwasher previously removed
and tighten all three screws.
FAN MOTOR
ASSEMBLY BLACK
WIRE CONNECTOR
LIGHT KIT ASSEMBLY
BLACK WIRE CONNECTOR
LIGHT KIT ASSEMBLY DRIVER
AND ARRAY CONNECTORS
Figure 23
6.3
Disengage the black wire connector from the fan motor
assembly to the Light Kit Assembly black wire connector
(Figure 23).
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!
Page 13