Installation & Assembly

18
7. How to Wire Your Ceiling Fan (Continued)
CEILING
COVER
LOCKWASHERS (2)
THREADED
STUDS (2)
KNURLED
KNOBS (2)
Figure 34
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
WARNING
!
7.7
Lift the ceiling cover up to the threaded studs and turn
until studs protrude through the holes in the ceiling
cover (Figure 34).
Secure the ceiling cover in place by sliding lockwashers
over the threaded studs and installing the two knurled
knobs (supplied in parts bag). (Figure 34).
Tighten the knurled knobs securely until the ceiling
cover fits snugly against the ceiling and the hole in the
ceiling cover is clear of the downrod.
7.8
Wire Diagram (Figure 35).
STANDARD ON-OFF WALL
SWITCH OR OPTIONAL
SW605 WALL CONTROL
BLACK
BLACK
WHITE
RED
BLACK
WHITE
HANGER BALL
GREEN WIRE (GROUND) FROM
HANGER BALL AND HANGER
BRACKET
TWO-CONDUCTOR
CABLE (WITH
GROUND)
BLACK
(HOT)
WHITE
GROUND
TO
120-
VOLT
SUPPLY
WHITE
BLUE
WHITE
BLUE
RECEIVER
Figure 35
Page 18