Installation & Assembly

20
8. Light Kit Assembly Replacement (Continued)
8.4
Disengage the fan motor assembly black wire connector
from the black wire connector of the new Light Kit
Assembly (Figure 38).
Disengage the fan motor assembly white wire connector
from the white wire connector of the new Light Kit
Assembly (Figure 38).
8.5
Install new Light Kit Assembly by reversing Steps 8.4
through 8.2.
8.6
Restore electricity and verify function of the Light Kit.
FAN MOTOR
ASSEMBLY
BLACK WIRE
CONNECTOR
LIGHT KIT ASSEMBLY
BLACK WIRE CONNECTOR
FAN MOTOR ASSEMBLY
WHITE WIRE CONNECTOR
LIGHT KIT ASSEMBLY
WHITE WIRE CONNECTOR
LIGHT KIT
ASSEMBLY
Figure 38
8.7
Method 2A - Replacing the Driver Assembly.
Remove the Light Kit Assembly from the Ceiling Fan per
Instructions 8.2 through 8.4.
If Replacing Only the LED Array, Proceed to
Instruction 8.12.
8.8
Squeeze and unclip the Light Kit Assembly Driver two
pin connector off of the Light Kit Assembly Array
connector (Figure 39).
LIGHT KIT ASSEMBLY
DRIVER TWO PIN
CONNECTOR
LIGHT KIT ASSEMBLY
ARRAY CONNECTOR
LIGHT KIT
ASSEMBLY
LIGHT KIT
ASSEMBLY
DRIVER
Figure 39
8.9
Gently pull up on the Light Kit Assembly Driver to
unstick the adhesive foam tape from the bottom of the
Driver (Figure 40).
Remove the old Light Kit Assembly Driver.
Discard the Light Kit Assembly in the correct recycle
bin.
LIGHT KIT
ASSEMBLY
LIGHT KIT
ASSEMBLY
DRIVER
ADHESIVE
FOAM TAPE
Figure 40
Page 20