Installation & Assembly

21
8. Light Kit Assembly Replacement (Continued)
8.12
Method 2B - Replacing the Array Assembly.
Remove the Light Kit Assembly from the Ceiling
Fan per Instructions 8.2 through 8.4.
8.13
Squeeze and unclip the Light Kit Assembly Driver two
pin connector off of the Light Kit Assembly Array
connector (Figure 42).
LIGHT KIT ASSEMBLY
DRIVER TWO PIN
CONNECTOR
LIGHT KIT ASSEMBLY
ARRAY CONNECTOR
LIGHT KIT
ASSEMBLY
LIGHT KIT
ASSEMBLY
DRIVER
Figure 42
8.10
Remove the paper backing from the adhesive foam tape
on the bottom of the new Light Kit Assembly Driver.
Place the new Light Kit Assembly Driver into the
assembly, aligning it directly where the old Driver had
been (Figure 41).
Press firmly on the Light Kit Assembly Driver to adhere
it to the Light Kit Assembly.
If Also Replacing the LED Array, Proceed to
Instruction 8.12
If Finished - Reconnect the Light Kit Assembly Driver
two pin connector to the Light Kit Assembly Array
connector (Figure 41).
Reassemble the repaired Light Kit to the Light Kit
Adapter following Instructions 8-4 through 8.2.
8.11
Restore electricity and verify function of the light kit.
LIGHT KIT ASSEMBLY
DRIVER TWO PIN
CONNECTOR
LIGHT KIT ASSEMBLY
ARRAY CONNECTOR
LIGHT KIT
ASSEMBLY
LIGHT KIT
ASSEMBLY
DRIVER
Figure 41
Page 21