Installation & Assembly

25
11. Setting Operating Frequency of Remote Control
11.1
Your remote control has code switches which must be
set in one of 32 possible code combinations
(Figure 48). The five levers (numbered 1, 2, 3, 4, and 5)
on the switches are factory-set in the ON (up) position.
Change the switch settings as follows (Figure 50):
11.2
Slide the five switch levers in the remote control to your
choice of ON (up) or down positions. Use a ball-point
pen or small screwdriver and slide the levers firmly up
or down.
11.3
When power is restored, push and hold the fan OFF
button ( ) for 3 to 5 seconds to set the code in the
receiver.
NOTE: Prior to operation of the fan and light from
the remote control, set the fan speed to HIGH (
....
)
and turn the light ON ( ).
11.4
To set the desired fan speed, press one of the four
buttons (
.
,
..
,
...
,
....
) to operate your fan from low to high
speeds.
11.5
To turn the downlight on, press and release the ( )
button. The light will turn on at the light intensity
previously selected.
11.6
To vary the intensity of the light, hold the
( ) button down until the desired light intensity is
reached, then release the button.
NOTE: When turning the light on, light will turn on
at the light intensity previously selected.
Your remote control has full control of your fan and
light.
HIGH TO LOW
BUTTONS
POWER
INDICATOR
LIGHT
LIGHT
BUTTON
FAN
BUTTON
STORAGE
BRACKET
Figure 50
Fan installation must be completed, including the
installation of the fan blades, before testing the remote
control.
WARNING
!
Page 25