Installation & Assembly

6
3. Ceiling Fan Assembly (Continued)
THREE 80" MOTOR LEADS
4.5" DOWNROD
Figure 6
3.6
Separate, untwist and unkink the three 80” motor leads.
Route the three motor leads through the 4.5” downrod
(Figure 6).
PHILLIPS HEAD SETSCREW
(LOOSENED)
HANGER BALL
4.5" DOWNROD
PIN
GREEN GROUND WIRE
Figure 5
3.5
Remove the hanger ball by loosening the Phillips head
setscrew in the hanger ball until the ball falls freely
down the 4.5” downrod (Figure 5).
Remove the pin from the 4.5” downrod, then remove
the hanger ball (Figure 5).
Retain the pin and hanger ball for reinstallation in
Step 3.11.
PARTIALLY ASSEMBLED
CEILING FAN
STYROFOAM
Figure 4
3.4
Carefully turn the partially assembled ceiling fan right
side up and position the fan on the styrofoam in
preparation for final assembly (Figure 4).
Page 6