Installation & Assembly

7
MOTOR
COUPLING
4.5"
DOWNROD
LOOSEN
PHILLIPS HEAD
SETSCREWS (2)
Figure 7
3.7
Loosen the two setscrews in the motor coupler for
installation of the downrod (Figure 7).
Seat the downrod in the motor coupler (Figure 7).
Rotate and align the downrod holes with all the holes in
the motor coupler (Figure 7).
3. Ceiling Fan Assembly (Continued)
HAIRPIN
CLIP
MOTOR
COUPLING
RETIGHTEN
PHILLIPS HEAD
SETSCREWS (2)
CLEVIS
PIN
HAIRPIN
CLIP
CLEVIS
PIN
Figure 8
3.8
Align the clevis pin holes in the downrod with the holes
in the motor coupler.
Install the clevis pin and secure with the hairpin clip
(Figure 8).
The clevis pin must go through the holes in the motor
coupler. It is critical that the clevis pin in the motor
coupler is properly installed and securely tightened.
Retighten the Phillips head setscrews to secure the
downrod to the motor (Figure 8).
It is critical that the clevis pin and setscrews in the
motor coupler are properly installed and securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
WARNING
!
GROMMET
COUPLING
COVER
DOWNROD
FAN MOTOR
HOUSING
Figure 9
3.9
Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on the
downrod until it rests on the fan motor housing
(Figure 9).
Page 7