User's Manual

ALDER SIMPLE

1-855-999-7872

the row of the sensor for which you wish to adjust the chime

settings > on the “Chime” row tap “ON” or “OFF” to turn the chime

on or off. If the panel’s universal volume settings are set to “0”

then the chimes will default to “Off” and cannot be turned on

unless the panel volume is set to at least 1.

TURN VOICE ON/OFF

To turn Voice Announcements on or off, go to Settings > Enter

your 4-digit Master Code > Sensors > Select the sensor type >

Tap “Edit” on the row of the sensor for which you wish to adjust

the voice settings > on the “Voice” Row tap “ON” or “OFF.” If the

panel’s universal volume settings are set to “0” then voice

announcements will default to “OFF” and cannot be turned on

unless the panel volume is set to at least 1.

TEST SENSOR

To test a sensor, go to Settings > Enter your 4-digit Master

Code > Sensors > Select the sensor type > Tap “Edit” on the row

of the sensor for which you wish to test > Tap “Test Sensor” on

the bottom of the screen > Trigger the sensor > the panel will

beep and the screen will turn green if the sensor successfully

triggered. Doors and Windows must be opened and closed.

SWINGER SHUTDOWN

This is a non programmable default setting that is enabled when

a sensor or zone is repeatedly tripping. The system will ignore

subsequent trips after a certain number of trips have occured

until the zone is manually restored by disarming the panel or

automatically reset after eight (8) or more hours without further

trips on the zone. Default is set to two trips before Swinger

Shutdown is enabled.

CROSS ZONING

Enabling cross zoning will require multiple zones to be triggered

before the alarm will sound and transmit.

If you wish to create a cross zone, please consult with a technician

by calling technical support at: 1-855-999-7872

DOOR SENSORS

CHANGE DOOR SENSOR ENTRY DELAY

By default, Door Sensors have a 30 second Entry Delay in order

to allow time to disarm the system when a door is opened. If you

want to change a door’s Entry Delay Length, go to Settings >