User's Manual

USER MANUAL

WWW.ALDER.COM

Enter your 4-digit Master Code > Sensors > Doors > Tap “Edit” on

the row of the door sensor for which you wish to change the Entry

Delay > on the Entry Delay Row use “-“ and “+” to adjust the

length of the entry delay. Options are in 15 second increments

between 0 and 4:15.

CHANGE DOOR SENSOR BATTERIES

Open the contact sensor (large piece) by finding the small side

with three vertical lines. Insert your fingernail or a flat head

screwdriver into the hole and pull the cover toward you. The

Sensor requires two CR2032 batteries.

WINDOW SENSORS

Window Sensors do not have an entry delay. Triggering a Window

Sensor when the system is armed will always cause the alarm to sound

immediately (unless the window sensor has been bypassed).

CHANGE WINDOW SENSOR BATTERIES

See ‘Change Door Sensor Batteries’ above.

MOTION SENSORS

Motion Sensors have a detection range of 90 degrees and detect

motion up to 45 feet away. They detect movement across a room

or hallway and should be used to secure larger, high traffic areas.

By default, Motion Sensors have an entry delay of 0 seconds. To

preserve battery life, Motion Sensors will go into “sleep mode” for

three minutes after being triggered and not trigger again until

three minutes have passed

CHANGE ENTRY DELAY

To change a Motion Sensor’s Entry Delay Length go to Settings

> Enter your 4-digit Master Code > Sensors > Motions > Tap

“Edit” on the row of the Motion Sensor for which you wish to

change the Entry Delay > on the Entry Delay Row use “+“ and “-

” to adjust the length of the entry delay. The Default is set to 0

seconds. We recommend keeping the motion entry delay set to

“0” unless a door is within range of the Motion Sensor and

opening the door would trigger the Motion Sensor.

ADJUST ACTIVE IN STAY MODE

The “Active in Stay” mode is used when the Motion Sensor is

protecting an area that is very rarely used. To set a Motion Sensor

as Active in Stay Mode go to Settings > Enter your 4-digit Master

Code > Sensors > Motions > Tap “Edit” on the row of the Motion

Sensor for which you wish to change the Active in Stay mode