User's Manual

ALDER SIMPLE
22
1-855-999-7872
SMOKE SENSORS
FIRE ALARM VERIFICATION
To turn a Smoke Sensor’s Fire Alarm Verification setting ON or
OFF go to Settings > Enter your 4-digit Master Code > Sensors
> Smoke > Select the Smoke sensor type > Tap “Edit” on the row
of the Smoke Sensor for which you wish to change the Fire Alarm
Verification > on the “Fire Alarm Verification” row tap “ON” or
“OFF” > Verify that you want to change this setting.
Turning Fire Alarm Verification “ON” will require the sensor to be
violated twice in two minutes, or remain violated for 30 seconds
before the alarm will sound. By default, this setting is turned OFF.
SMOKE / HEAT / FREEZE DETECTOR
The Smoke/Heat/Freeze Detector’s function is to alert your
system of smoke, as well as excessive heat or cold detection. It is
designed to provide detection of at least a 35-foot radius. This
detector communicates with the panel to send alarm, tamper, and
battery condition messages to the systems receiver. DO NOT
install the sensor near a kitchen, stove, hot water heater, furnace,
or directly outside a bathroom.
TURN INDIVIDUAL SENSOR ZONES ON/OFF
The Smoke / Heat / Freeze Detector allows you to turn basic
functionality on and off. For example you may have the smoke and
heat sensors activated while freeze detection is suspended. To
adjust these functions go to Settings > Enter your 4-digit Master
Code > Sensors > Smoke / Heat / Freeze > Tap Edit on the row of
the sensor you wish to adjust > on the sensor row tap “ON” or
“OFF”.
TEST A SMOKE / HEAT / FREEZE DETECTOR
To test a Smoke / Heat / Freeze Detector, go to Settings > Enter
your 4-digit Master Code > Sensors > Smoke > Smoke / Heat /
Freeze > Tap Edit on the row of the sensor you wish to test > Tap
the Test Sensor button > Follow the on-screen instructions.
Press the test button on the detector until you hear three beeps.
More sets of three beeps will follow. Before the beeps stop, a
signal will be sent to the panel to tell you the sensor has tested
successfully.
CHANGE SMOKE / HEAT / FREEZE DETECTOR BATTERIES
To change the Smoke/Heat/Freeze Detector batteries twist
the cover of the detector clockwise to remove old batteries.