User's Manual

USER MANUAL
23
WWW.ALDER.COM
This detector requires 3 AAA E92 batteries. Make sure to wait 20
seconds before installing the new battery to ensure a proper power-
down. Insert the batteries in the compartment. Always match the plus
(+) sign on the battery with the flat side of the compartment and the
minus (-) sign on the battery with the spring side of the compartment.
Reinstall by mounting the cover to the base and turning the detector
clockwise.
SMOKE + CO DETECTOR
TEST A SMOKE + CO DETECTOR
To test a Smoke + CO Detector, go to Settings > Enter your 4-digit
Master Code > Sensors > Smoke > Smoke + CO > Tap Edit on the row
of the sensor you wish to test > Tap the Test Sensor button > Follow
the on-screen instructions.
Press the test button in the center on the cover of the detector until
you hear one beep. The detector will have two sets of three beeps (for
smoke) followed by two sets of four quick beeps (for CO) indicating
that the detector is operating normally. Before the beeps stop, a signal
will be sent to the panel to tell you the sensor has tested successfully.
CHANGE YOUR SMOKE + CO DETECTOR BATTERIES
When the detector batteries are low the detector will chirp
approximately every 60 seconds. This detector has a sealed Lithium
battery and is not replaceable. The detector will need to be replaced.
CARBON MONOXIDE (CO) DETECTOR
The Carbon Monoxide (CO) Detector communicates with the panel to
send alarm, tamper, and battery condition messages to the systems
receiver.
TEST A CO DETECTOR
To test a CO Detector, go to Settings > Enter your 4-digit Master
Code > Sensors > Smoke > Carbon Monoxide > Tap Edit on the row
of the sensor you wish to test > Tap the Test Sensor button > Follow
the on-screen instructions.
Press the test button on the cover of the detector until you hear four
quick beeps. The detector will have one more set of four quick beeps
followed by one beep indicating that the detector is operating
normally. Before the beeps stop, a signal will be sent to the panel to
tell you the sensor has tested successfully. If the detector does not
make the beeping sounds the detector will need to be replaced.