User's Manual

ALDER SIMPLE
24
1-855-999-7872
CHANGE CO DETECTOR BATTERIES
To change the CO Detector batteries twist the detector
counterclockwise from its mounting base. Make sure to wait
20 seconds before installing the new battery to ensure a proper
power- down. The CO Detector requires one CR123A battery.
Insert the battery in the compartment. Always match the plus
(+) sign on the battery with the flat side of the compartment and
the minus (-) sign on the battery with the spring side of the
compartment. Reinstall by mounting the detector to the base and
turning the detector clockwise.
MEDICAL PENDANT
The Medical Pendant’s main functionality is to send emergency
signals to the system whether the system is armed or disarmed.
To trigger the button and send emergency signals press the
Medical Pendant Help button in the center for approximately 2
seconds.
TEST A MEDICAL PENDANT
To test a Medical Pendant, go to Settings > Enter your 4-digit
Master Code > Sensors > Medical > Tap Edit on the row of the
pendant you wish to test > Tap the Test Sensor button > Follow
the on-screen instructions.
Press the button on the center of the pendant and hold it for two
seconds. A signal will be sent to the panel to tell you the pendant
has tested successfully.
CHANGE MEDICAL PENDANT BATTERY
To change the Medical Pendant battery remove the top cover by
inserting a small flathead screwdriver into the slot located on the
bottom right corner and twist. This sensor requires one CR123A
battery. When installing the new battery make sure the + sign is
facing out.
FLOOD / FREEZE SENSOR
The Flood / Freeze Sensor is designed to detect pooling and
standing water when it makes contact across the gold probes on
the bottom of the sensor. It also detects the potential of freezing
temperatures that could damage water pipes.
PLACEMENT
Place Flood / Freeze Sensors anywhere you wish to detect a flood
or freezing temperatures. Common locations are: behind a toilet;
under a sink, dishwasher, or fridge; behind a washing machine;