User's Manual

USER MANUAL

WWW.ALDER.COM

near a water heater; or in a basement.

TEST A FLOOD / FREEZE SENSOR

To test a Flood / Freeze Sensor, go to Settings > Enter your 4-digit

Master Code > Sensors > Flood > Tap Edit on the row of the

sensor you wish to test > Tap the Test Sensor button > Follow the

on-screen instructions.

Press the test button on the bottom of the sensor and hold it for

two seconds. A signal will be sent to the panel to tell you the

sensor has tested successfully.

CHANGE THE FLOOD / FREEZE SENSOR BATTERY

To change the Flood / Freeze Sensor battery, remove the rubber

feet on the bottom of the sensor then remove the screws and

casing. This sensor requires one CR2450 battery. Be sure to have

the plus (+) side of the battery facing you. After the new battery

has been replaced in the compartment, replace the casing, screws

and rubber feet on the bottom of the sensor.

GLASS BREAK DETECTOR

The Glass Break Detector typically provides a 15-foot maximum

detection range, 360-degree maximum horizontal sensing angle,

and dual-stage glass break detection. Walls, partitions, and other

large objects will obstruct sound and decrease detection range.

Glass Breaks are typically mounted on the ceiling but can be

placed on an opposite or adjacent wall to the window being

protected. Do not place the Glass Break Detector on a window or

glass surface.

TEST A GLASS BREAK DETECTOR

To test a Glass Break Detector, go to Settings > Enter your 4-digit

Master Code > Sensors > Glass Break > Tap Edit on the row of the

sensor you wish to test > Tap the Test Sensor button > Follow the

on-screen instructions.

Rotate the detector counter-clockwise until it stops then remove it

one inch from the mounting plate. Place the detector back on the

mounting plate with the raised marks on the outside edges

aligned and rotate it clockwise to re-mount the detector on the

mounting plate. A signal will be sent to the panel to tell you the

sensor has tested successfully.