Installation & Assembly

Parts List

INSTRUCTIONS

Tools Required: None

9-BAY BASE

CHARGING STATION

KBEP-BASE9

In the Box:

3 4

Power Cord

Battery Charging Options

Turn on power switch , also located on rear

panel of Base Charging Station.

Insert Rechargeable Battery(s) into slot(s) on front

of Base Charging Station.

When fully connected, Rechargeable Battery indicator

lights will blink to show charging status.

NOTE: Batteries will ship only partially charged and

must be fully charged before ﬁrst use.

Plug IEC power cord into rear of Base

Charging Station.

Plug power cord into available AC wall outlet.

9-Bay Base Charging Station

Clamp-On

Desktop Charging Unit

Rechargeable Battery

Ships / Sold Separately:

1st dot blinking

= 0 to 24% charged

2nd dot blinking, 1st dot solid

= 25 to 49% charge

3rd dot blinking, 1st & 2nd dot solid

= 50 to 74% charged

4th dot blinking, 1st, 2nd, & 3rd dot solid

= 75 to 99% charged

PAGE 1
Parts List 9-BAY BASE CHARGING STATION KBEP-BASE9 In the Box: Power Cord INSTRUCTIONS Tools Required: None Ships / Sold Separately: 9-Bay Base Charging Station Rechargeable Battery 1 Plug IEC power cord into rear of Base Charging Station. 3 Turn on power switch , also located on rear panel of Base Charging Station. Clamp-On Desktop Charging Unit Battery Charging Options 2 Plug power cord into available AC wall outlet.
PAGE 2
5 TROUBLESHOOTING Indicator lights not illuminating* 1. Ensure Base Charging Station is fully plugged in and power switch is turned on. 2. Ensure Rechargeable Battery is properly connected to Base Charging Station. 3. Turn power switch off, and then on again. Allow two (2) hours for Batteries to fully charge. When all four indicator lights illuminate solid, a Battery is fully charged. 4. If steps 1 through 3 do not work, contact customer service.